LM datasheet, LM pdf, LM data sheet, datasheet, data sheet, pdf, National Semiconductor, 80V Triple Bias Clamp. Part Number: LM, Maunfacturer: National Semiconductor, Part Family: LM, File type: PDF, Document: Datasheet – semiconductor. The LM driver is an Integrated 80V triple bias clamp cir- . Note: Information contained in this data sheet is preliminary and may be subject.

Author: Zolonris Yokree
Country: Pakistan
Language: English (Spanish)
Genre: Sex
Published (Last): 12 August 2005
Pages: 61
PDF File Size: 19.20 Mb
ePub File Size: 1.70 Mb
ISBN: 830-8-59845-785-7
Downloads: 91409
Price: Free* [*Free Regsitration Required]
Uploader: Gotilar

LM Selling Leads, Price trend, LM DataSheet download, circuit diagram from

For guaranteed specifications and the test conditions, see the Electrical Characteristics. The DC clamp circuit amplifies the input signal by and the gain is set by the resistor ratio of 18R and R.

All voltages are measured with respect to GND, unless otherwise specified. The guaranteed specifications apply only for the test conditions listed. Operating Ratings indicate conditions for which the device is functional, but do not guarantee specific performance limits.


LMNA National Semiconductor, LMNA Datasheet

Life support devices or systems are devices or systems which, a are intended for surgical implant into the body, or b support or sustain life, and whose failure to perform when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in a significant injury to the user.

F capacitor should be datashedt from the supply pin, Vcc, to ground, as close to the supply and ground datasheeh as is practical. National Semiconductor Corporation Americas Email: A critical component is any component of a life support device or system whose failure to perform can be reasonably expected to cause the failure daasheet the life support device or system, or to affect its safety or effectiveness. No additional components are required to protect the LM from arc damage.

Application Circuit The application circuit shown in Figure 5 is designed to help clamp the voltage at the output of the driver to the desired level. Figure 2 shows the test circuit used for evaluation of the LM Clamp Amplifier.


To obtain demonstration boards contact the National Semiconductor Sales Office in your region.

Each amplifier has its km2480 internally set to Some performance characteristics may change when the device is not operated under the listed test conditions. Absolute Maximum Ratings indicate limits beyond which damage to the datasheett may occur.

The DC transfer function is shown in Figure 4. Capacitor C4 stabilizes the entire node at the anode of the clamp diode, D3, by creating a low impedance at high frequencies. Simplified Schematic One Channel?

It shows all the components necessary to optimize performance as well as to protect against damage from a CRT arc event. The output requires pull-up resistor to 80V.

Information contained in this data sheet is preliminary and may be subject to change without notice.